Sliding driveway gates
Wrought iron
Wood & steel frame
Farm & ranch
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterDriveway Gate in San Antonio, TX
Driveway Gate Installation services in San Antonio typically cost between $2,800 and $9,500 depending on gate size, material, and whether you’re adding an electric opener. Most single-swing steel driveway gates on standard residential lots run $3,200 to $5,200 installed, and we can usually complete the job in one to two days. Call (325) 252-5195 for a written quote before any work begins.
A driveway gate isn’t just a barrier across your entrance. It’s the first thing you see when you come home, and in San Antonio it works hard: limestone dust from new construction in Stone Oak, monsoonal downpours in Alamo Heights, and summer heat that regularly pushes past 100 degrees all take a toll on hinges, posts, and opener motors. Our Gate Installation in San Antonio service handles the full scope, but this page focuses on what you need to know specifically about driveway gates: the right width for your vehicles, the post depth our soil requires, and what’s actually worth spending money on.
Latch and Post Gate Repair San Antonio is part of the Cedarwell family of independently owned and operated gate specialists. We’ve been installing and repairing driveway gates here since 2009, and every job follows the same documented routine: a written price before work starts, shoe covers and drop cloths on every visit, and a photo of the clean-up before we leave. Your driveway is the entrance to your home, which means our crew ends up working near your front door, your front walk, and often inside your garage. We treat all of it like we’d treat our own place.
Key Takeaways
- Driveway gate installation in San Antonio runs roughly $2,800 – $9,500; most standard single gates fall between $3,200 and $5,200 installed.
- San Antonio soil, especially in areas with heavy clay like Helotes and parts of the far west side, requires deeper post footing than the national average. We set steel posts in concrete at a minimum of 36 – 42 inches.
- You’ll get a written price before we touch anything, and it won’t change mid-job unless you add scope.
- The 365-Day Done Right Promise covers every driveway gate we install. If it’s not right, we make it right.
When You Need Driveway Gate
Not every situation calls for a full replacement. Sometimes the post is still solid and the gate just needs re-hanging. Sometimes you’re building a new fence and want the driveway entrance done properly from the start, or need a Pedestrian Gate alongside it. Here’s what we most often see across San Antonio:
- Your gate drags or scrapes the driveway. In San Antonio’s clay-heavy soil, posts shift seasonally as the ground swells after rain and contracts in drought. A gate that dragged slightly in March may bind hard by August. Re-setting the post with a deeper concrete footing usually fixes this permanently.
- You’re installing a fence and want the gate to match. Whether it’s wrought-iron in Monte Vista or horizontal cedar in Terrell Hills, the driveway gate needs to be hung before the fence sections go in. Doing it in the right order saves you from re-cutting rails and re-drilling brackets later.
- You bought a home with an existing gate that doesn’t open smoothly. This is common in older neighborhoods like Jefferson and Woodlawn Lake, where gates were installed 15 or 20 years ago on shallow footings. We can re-hang the existing gate on new posts, or replace just the hinge hardware if the structure is still sound.
- You’re adding an opener to a manual gate. If you’re tired of getting out of the car in the rain to swing the gate open, we can add an opener from Ghost Controls, Viking, or DoorKing. The concrete pad for the opener arm needs to be set before the gate is hung, so planning matters.
- Your kids or pets can slip through the gap. As gates settle, the gap at the hinge side widens. In homes with small dogs or toddlers, a two-inch gap becomes a real problem. Re-hanging the gate tighter to the post is usually a same-day fix.
- The gate post is rusted through at the base. Steel posts in San Antonio sit in soil that holds moisture against the metal year-round. If the post has rusted through where it meets the concrete, the fix is a new post set deeper, not a patch job.
Our Driveway Gate Process
Here’s exactly how a driveway gate installation goes when you call us:
- Call and talk to a live person. You’ll reach someone immediately, any hour of the day or night. We ask about your existing gate, your fence, your driveway surface, and what you want the gate to do. Then we schedule a visit.
- On-site measurement and soil check. We measure the driveway opening, check how level the ground is, and look at what’s under the surface where posts will go. In San Antonio we’re usually drilling through caliche or clay, and we set posts a minimum of 36 – 42 inches deep in concrete so the gate stays true through wet and dry seasons.
- Written price, no pressure. Before any work starts, you get a written number that includes the gate, posts, hardware, concrete, and labor. If you want an opener added, that’s a separate line item. You decide what you want. No one will pressure you to add anything.
- Installation day. Our technicians arrive in uniform, background-checked, and ready to work. We lay drop cloths anywhere we’ll be walking or setting tools, and we put on shoe covers before stepping inside your garage or home. If your kids are napping, we can work around quiet hours.
- Level, hang, and test the gate. We set the posts, let the concrete cure properly, hang the gate, and adjust the hinges until it swings smooth and closes true. If there’s an opener, we program the remotes, set the travel limits, and demonstrate everything with you before we leave.
- Clean-up photo and walkthrough. Before we leave, we sweep the work area, pick up every scrap, and take a photo of the clean site. You’ll see it before we pull out of the driveway. Then we walk the gate with you and answer any questions.
Every gate comes down to two parts: the latch that holds it and the post that carries it. That’s the job we focus on. The brands we service most on San Antonio driveway gates are Viking, Ghost Controls, and DoorKing, and our technicians are trained on each one so the opener gets wired and programmed correctly the first visit.
Driveway Gate Pricing in San Antonio
Here are honest ranges for How Much Does Gate Installation Cost? (2026 Price Guide) - San Antonio, TX right now. These reflect what we’ve quoted across the city over the past year, from Alamo Ranch to East Side neighborhoods:
| Gate Type / Work | Typical Range |
|---|---|
| Single swing steel gate, manual, installed | $3,200 – $5,200 |
| Single swing steel gate with opener (Ghost Controls or Viking) | $4,500 – $6,800 |
| Double swing steel gate, manual, installed | $5,800 – $8,500 |
| Double swing gate with opener | $7,200 – $9,500 |
| Re-hang existing gate on new posts (both posts replaced) | $1,400 – $2,300 |
| Replace hinge hardware only (gate stays in place) | $350 – $700 |
What moves the price:
- Gate material and weight. A lightweight aluminum gate costs less than solid steel, but aluminum dents more easily and isn’t always the right choice for a high-traffic driveway. We’ll show you the trade-offs in writing.
- Soil conditions at the post locations. If we’re drilling into solid caliche, it takes longer than drilling through soft clay. We price for what we actually find, not an average.
- Driveway slope. A gate on an uphill driveway needs different hinge geometry and sometimes a taller gate to maintain ground clearance. It’s a small detail that matters when the gate has to open over the high point of the drive.
- Opener brand and features. A basic Ghost Controls single-arm opener is the most affordable option. DoorKing and Viking systems with battery backup and vehicle sensors cost more, and they’re worth it if your gate cycles many times a day.
Most standard gate and latch replacements run between $350 and $2,300, and you’ll see the exact number in writing before we touch anything. Estimates are free, and there’s no obligation to accept the quote. Call (325) 252-5195 to schedule a measurement visit.
FAQs – Driveway Gate
How much does a driveway gate cost in San Antonio?
A standard single-swing steel driveway gate in San Antonio costs $3,200 to $5,200 installed, and adding an electric opener brings the total to $4,500 to $6,800. Double gates run $5,800 to $9,500 depending on width and opener choice. Call (325) 252-5195 for a free on-site estimate with a written price before any work starts.
How deep do driveway gate posts need to be in San Antonio?
In San Antonio’s clay and caliche soil, driveway gate posts should be set 36 to 42 inches deep in concrete. Shallow footings set at 24 inches are a common cause of gate sag and dragging after the first full wet-dry season. We dig deeper than the minimum because the soil here moves.
Can you install a driveway gate opener on an existing gate?
Yes, and it’s a common request. We can add an opener from Ghost Controls, Viking, or DoorKing to most existing steel gates, provided the gate is still hung square and the posts are solid. We’ll check the gate first and let you know if the post needs re-setting before the opener goes on.
How long does driveway gate installation take?
Most single driveway gate installations are completed in one day, with a second visit to wire and program the opener if one is included. Concrete for the posts needs time to cure before the final hang, so we typically schedule the gate hang for 24 to 48 hours after the posts are set.
Is it cheaper to repair or replace a driveway gate?
If the gate panel itself is straight and not rusted through, repair is almost always cheaper. Re-hanging on new posts runs $1,400 to $2,300, while a full replacement starts around $3,200. We’ll tell you honestly which one makes sense for your specific gate, and you’ll see the numbers in writing before you decide.
Why San Antonio Homeowners Call Latch and Post Gate Repair
Cody Beckman leads our team in San Antonio, and he’s built the operation around a simple idea: the way a crew treats your home matters as much as the gate itself. We lay drop cloths on the floor and put on shoe covers before we step inside your home or garage, so your floors stay clean. We choose pet-safe lubricants where there’s a choice, and we can schedule around nap time if quiet matters to your family.
The Cedarwell C.A.R.E. values are what our technicians work by on every driveway gate job: Clean up like it’s our own home, Ask before we move or touch anything, Respect the family’s time and quiet hours, and Explain the price before the work. These aren’t optional. They’re standard on every visit we make in San Antonio.
Every driveway gate installation and repair we complete is covered by the 365-Day Done Right Promise. If the gate isn’t right, if the opener doesn’t cycle cleanly, if the post shifts within a year, we come back and make it right. No argument, no fine print.
We’ve been part of the Cedarwell family of gate specialists since 2009, serving homeowners across San Antonio and the surrounding area. When you call, a live person answers, day or night. You won’t get a voicemail or a call-back queue.
If your driveway gate needs installing, re-hanging, or a new opener, call us at (325) 252-5195 for a free estimate. We’ll measure, we’ll quote, and you’ll have the number in writing before any work begins. That’s how we’ve done it since day one.
Written by Cody Beckman, Owner at Latch and Post Gate Repair San Antonio, serving San Antonio.